AiM Solo 2 DL RPM and Power Wiring Harness

The AiM V02589020, called the AiM Solo 2 DL RPM Input Wire, is used to connect your AiM Solo 2 DL to an older generation (non-ECU) vehicle. On the bottom right of your Solo 2 DL there is an 8 pin connector that you can connect to the low voltage side of your coil. The peak can be anywhere from 150 to 400 V or from a square wave with a peak of 5 to 50 V.

If you have a vehicle with no ECU or OBD-2 Port or a MSD ignition box, this is your easiest way to log RPM. By connecting the positive and negative wires, your Solo 2 DL unit will automatically top off the internal battery and power all down line appliances, such as SmartyCams and other powered devices.

AiM Solo 2 DL RPM Input Wire Details:

• Manufacturer: AIM
• Manufacturer part number: V02589020
• End 1: Male 712 8 Pin Screw-in
• End 2: Flying lead (open wires) 12 V Positive , Negative, and RPM input
• Length: 2 Meters

AiM Solo 2 DL RPM Input Wire Uses:

• Solo 2 DL to older external coil engines
• Solo 2 DL to RPM tach lead
• Solo 2 DL to MSD ignition box